Avaya Configuring PPP Services Bedienungsanleitung PDF herunterladen (Seite 24)

Configuring PPP Services

1-4

308639-14.00 Rev 00

Starting PPP

Services

When you add a PPP circuit, it is automatically enabled. To let data flow over this

interface, you must also enable an upper-layer routing protocol (such as IP, IPX,

or AppleTalk) to run on top of PPP. See the appropriate protocol-specific guides

for information on these upper-layer protocols.

Using the BCC

To enable IP routing on a given interface, navigate to the IP prompt and enter:

state enable

For example, the following command enables IP routing on the interface with the

IP address of 1.1.1.1.

ip/1.1.1.1# state enable

Using Site Manager

To enable IP routing over this PPP interface, do the tasks in the following table.

Note:

The BCC supports only IP as the upper-layer protocol.

Site Manager Procedure

You do this System responds

1. From the Protocols menu, choose

PPP

. The Interfaces menu appears.

2. Choose

Interfaces

. The Interfaces window opens.

3. Set

IP Enable

Enable

. (See

page A-3.)

4. Click on

to accept the default values

for all other PPP parameters.

The Configuration Manager window

appears.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 151 152

Keine Kommentare

Avaya Configuring PPP Services Bedienungsanleitung Seite 24