Avaya Configuring PPP Services Bedienungsanleitung PDF herunterladen (Seite 71)

Customizing PPP

308639-14.00 Rev 00

3-17

Using Site Manager

Disable and then reenable the Enable (LCP) parameter. You can change as many

parameters as necessary before forcing the renegotiation. After making all your

changes to these parameters:

Set the Enable (LCP) parameter to Disable and, if necessary, apply the

changes.

Reset the Enable (LCP) parameter to Enable and, if necessary, apply the

changes.

To force link renegotiation on this PPP interface, do the tasks in the following

table.

Enabling Link Control on a Line

The link control protocol (LCP) is enabled by default on the interface. Disabling

the Enable (LCP) parameter generates a “close” event to the LCP, and enabling

this event generates an “open” event to the LCP. A major use of this sequence is to

force LCP renegotiation on the interface during dynamic reconfiguration. Doing

so means that any changes you have made to the line parameters are included in

the negotiations.

Site Manager Procedure

You do this System responds

1. From the Protocols menu, choose

PPP

. The Interfaces menu appears.

2. Choose

Interfaces.

The Interfaces window opens.

3. Choose

Lines

. The Lines window opens.

4. Set

Enable (LCP)

Disable

(See page A-14.)

5. Click on

. The Interfaces window opens.

6. Choose

Lines

. The Lines window opens.

7. Set

Enable (LCP)

Enable

(See page A-14.)

8. Click on

. The Interfaces window opens.

1 2 ... 66 67 68 69 70 71 72 73 74 75 76 ... 151 152

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya Configuring PPP Services Bedienungsanleitung Seite 71

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Vernetzung Avaya Configuring PPP Services