Avaya Configuring PPP Services Bedienungsanleitung PDF herunterladen (Seite 66)

Configuring PPP Services

3-12

308639-14.00 Rev 00

For a description of the differences between multiline and multilink connections,

see “Differences Between Multiline and Multilink” in Chapter 2. For more

information about multiline connections, see Configuring Dial Services.

To configure the PPP mode on this interface, do the tasks in the following table.

Configuring Multilink Fragmentation

For multilink circuits that include different speed links and that may carry both

large and small packets, you can optionally enable multilink fragmentation. PPP

fragments packets only if doing so will improve the flow of data over the circuit.

When necessary, PPP splits packets into encapsulated fragments and then sends

the fragments over the lines in the multilink bundle, reassembling them on the

receiving peer into the proper sequence. PPP discards all fragments of an

incomplete reassembly. The number of fragments is always equal to or less than

the number of lines in the bundle. Multilink fragmentation is enabled by default.

When you enable fragmentation, you can specify the minimum size packet that

you want PPP to consider fragmenting. The default minimum size is 256 bytes.

Site Manager Procedure

You do this System responds

1. From the Protocols menu, choose

PPP

. The Interfaces menu appears.

2. Choose

Interfaces.

The Interfaces window opens.

3. Set

PPP Mode

. (See page A-12.)

4. If you have no other Interface parameters

to configure, click on

. Otherwise,

continue with the Interface configuration.

The Configuration Manager window

appears.

1 2 ... 61 62 63 64 65 66 67 68 69 70 71 ... 151 152

Keine Kommentare

Avaya Configuring PPP Services Bedienungsanleitung Seite 66