Avaya Configuring PPP Services Bedienungsanleitung PDF herunterladen (Seite 68)

Configuring PPP Services

3-14

308639-14.00 Rev 00

Disabling Network Control Protocols

To stop traffic from routing over a PPP interface, either

• Disable the NCP for the upper-level routing protocol.

For example, if you disable the NCP for IP (by setting the IP Enable

parameter to Disable), even though IP is still enabled on the interface, it is no

longer able to route traffic over the interface.

• Disable the upper-level routing protocol itself.

If you disable the routing protocol running on top of the PPP interface, you

also automatically disable the NCP for the routing protocol. For example,

disabling IP on an interface disables the NCP for IP as well.

Using the BCC

Navigate to the IP prompt and enter

state disable

For example, the following command disables IP routing on the interface with the

IP address of 1.1.1.1.

ip/1.1.1.1# state disable

Using Site Manager

To stop traffic from routing over this PPP interface, do the tasks in the following

table.

Site Manager Procedure

You do this System responds

1. From the Protocols menu, choose

PPP

. The Interfaces menu appears.

2. Choose

Interfaces.

The Interfaces window opens.

3. Set

IP Enable

Disable

. (See page A-3.)

4. If you have no other Interface parameters

to configure, click on

. Otherwise,

continue with the Interface configuration.

The Configuration Manager window

appears.

1 2 ... 63 64 65 66 67 68 69 70 71 72 73 ... 151 152

Keine Kommentare

Avaya Configuring PPP Services Bedienungsanleitung Seite 68