Avaya Configuring PPP Services Bedienungsanleitung Seite 51
- Seite / 140
- Inhaltsverzeichnis
- LESEZEICHEN
Bewertet. / 5. Basierend auf Kundenbewertungen
PPP Concepts
117360-A Rev. A 2-25
Configuring IP to Run over PPP Interfaces
When you enable numbered Internet Protocol (IP) support on a PPP interface, you
must also configure an adjacent host entry for the peer router. See Configuring IP
Services for instructions on configuring an adjacent host entry.
Detecting Loopback Conditions
As part of its network integrity checking, PPP tests for a loopback condition in
which, effectively, it is talking to itself and not communicating with the network.
Normally, you would want this feature enabled. For test purposes, however, you
can disable this loopback detection feature by using the Technician Interface.
After disabling this parameter, you must explicitly set it to Enable to reenable
loopback checking. See “Disabling Loopback Checking” in Chapter 3 for
instructions on how to set this parameter.
PPP Software Compatibility Issues
Starting with Version 12.00, the default Maximum Receive Unit (MRU) parameter
value for PPP is 1500, for compatibility with RFC 1661. If you have a network
with both version 11.02 (or later) and pre-11.02 Bay Networks routers, or Bay
Corporate LAN Access Module (CLAM
™
) routers configured with
Dial-on-Demand, Standby, or Dial Backup circuits, make sure that the value you
set for the PPP MRU parameter is the same for the central-site router and the
remote-site routers. See “Setting the Maximum Receive Unit (MRU)” on
page 3-39 for a complete description of how to do this.
If you need to configure PPP to run over a point-to-point connection between a
Version 5.x and a Version 11.xx or 12.00 router, read this section.
The features introduced in Version 11.0, namely asynchronous PPP and multilink
fragmentation, are available only with this and later versions.
Note: This section is not relevant for BayStream software.
- Configuring PPP 1
- Services 1
- Contents 5
- 117360-A Rev. A 11
- About This Guide 13
- Conventions 14
- Acronyms 15
- Bay Networks Customer Service 17
- How to Get Help 17
- Chapter 1 19
- Starting PPP Services 19
- Summary of PPP Services 20
- Starting Configuration Tools 21
- Starting PPP 22
- Using the BCC 23
- Using Site Manager 23
- Deleting PPP Services 24
- Where to Go Next 25
- Chapter 2 27
- PPP Concepts 27
- PPP Overview 28
- • Password Authentication 29
- • Challenge Handshake 29
- Routing over a PPP Link 30
- Initializing a PPP Interface 31
- 2-6 117360-A Rev. A 32
- 2-8 117360-A Rev. A 34
- One-Way Authentication 35
- Datagram Encapsulation 36
- PPP Dial Services Support 36
- Dial-on-Demand 37
- Bandwidth-on-Demand 37
- Dial Backup 37
- PPP Multiline 38
- PPP Multilink 38
- Using PPP Multilink 39
- 2-14 117360-A Rev. A 40
- Figure 2-4. Multilink Circuit 40
- Balancing Traffic Loads 41
- Using Multilink Fragmentation 42
- 2-18 117360-A Rev. A 44
- Monitoring PPP Link Quality 46
- PPP Data Compression 48
- PPP Line Parameters 50
- Detecting Loopback Conditions 51
- 2-26 117360-A Rev. A 52
- PPP Interoperability 53
- Chapter 3 55
- Customizing PPP 55
- 3-2 117360-A Rev. A 56
- Enabling PPP on an Interface 57
- Setting Up Remote Addresses 58
- Configuring AppleTalk 60
- 3-8 117360-A Rev. A 62
- 3-10 117360-A Rev. A 64
- Table 3-1. PPP Modes 65
- 3-12 117360-A Rev. A 66
- Configuring Data Encryption 67
- Customizing PPP Lines 68
- Editing PPP Line Parameters 69
- Setting the Restart Timer 72
- Customizing PAP 81
- Customizing CHAP 84
- 3-34 117360-A Rev. A 88
- 3-36 117360-A Rev. A 90
- Disabling Loopback Checking 93
- 3-42 117360-A Rev. A 96
- Appendix A 99
- Configuring PPP Services 100
- A-2 117360-A Rev. A 100
- 101
- A-8 117360-A Rev. A 106
- PPP Parameters 107
- 110
- A-16 117360-A Rev. A 114
- 116
- A-20 117360-A Rev. A 118
- 119
- A-24 117360-A Rev. A 122
- A-26 117360-A Rev. A 124
- A-28 117360-A Rev. A 126
- Appendix B 127
- Default PPP Configuration 127
- B-2 117360-A Rev. A 128
- Default PPP Configuration 129
- Appendix C 131
- PPP Statistics 131
- C-2 117360-A Rev. A 132
- Table C-1. PPP Statistics 132
- 117360-A Rev. A Index-1 133
- 117360-A Rev. A Index-3 135
- 117360-A Rev. A Index-5 137
- 117360-A Rev. A Index-7 139
Verwandte Produkte und Handbücher für Vernetzung Avaya Configuring PPP Services
Vernetzung Avaya Business Communications Manager - Interactive Voice Response Konfigurationsanleitung
(68 Seiten)
(68 Seiten)
Vernetzung Avaya 56/64K Bedienungsanleitung
(36 Seiten)
(36 Seiten)
Vernetzung Avaya BayRS and BCC Software Version 14.0.3.10 Fixed Anomalies Bedienungsanleitung
(10 Seiten)
(10 Seiten)
Vernetzung Avaya Configuring Aura Messaging 6.1 as a Voice Messaging Solution Bedienungsanleitung
(47 Seiten)
(47 Seiten)
Vernetzung Avaya Integrated Management Release 3.0 Enterprise Network Management Bedienungsanleitung
(76 Seiten)
(76 Seiten)
Vernetzung Avaya Business Communications Manager 5.0 - Configuration - System Bedienungsanleitung
(224 Seiten)
(224 Seiten)
Vernetzung Avaya P332MF Bedienungsanleitung
(182 Seiten)
(182 Seiten)
© 2020, manymanuals.de. Alle Rechte vorbehalten. | 0.082 s |
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Kommentare zu diesen Handbüchern