
Configuring PPP Services
3-24 117360-A Rev. A
Using Site Manager
To set the maximum number of configure-NAK packets allowed on this interface,
do the tasks in the following table.
Setting a Time Limit for Convergence
Convergence occurs when the peers have negotiated all the parameters needed to
establish a dial services connection. You can limit the amount of time that PPP
attempts to negotiate a switched PPP interface by setting the Convergence Timer
parameter.
This parameter applies only to a switched PPP interface. The convergence timer
specifies the maximum number of seconds allowed for the completed
negotiations. It limits the LCP negotiations and requires at least one NCP to
negotiate within the configured amount of time. The default value is 300 seconds.
If the timer expires before the negotiation completes, the connection is dropped.
The convergence timer allots the configured number of seconds for the LCP to
negotiate and allots the same period for one NCP to complete negotiations.
Using the BCC
The BCC does not allow you to configure this parameter.
Using Site Manager
To set the maximum time allowable for convergence for this interface, do the tasks
in the following table.
Site Manager Procedure
You do this System responds
1. From the Protocols menu, choose PPP. The Interfaces menu appears.
2. Choose Interfaces. The Interfaces window opens.
3. Choose Lines. The Lines window opens.
4. Set Max Configuration Failure Count.
(See page A-17.)
5. If you have no other PPP line parameters
to configure, click on OK. Otherwise,
continue with the Lines configuration.
The Interfaces window opens.
Kommentare zu diesen Handbüchern