Avaya Configuring PPP Services Bedienungsanleitung PDF herunterladen (Seite 58)

Configuring PPP Services

3-4 117360-A Rev. A

Setting Up Remote Addresses

Using Site Manager, you can deﬁne an address and node number (depending on

the requirements of the protocol you’ve chosen) that you want the remote peer to

use. That is, you can deﬁne an

• IP address

• IPX network number and node number

• AppleTalk node number

depending on the protocol you enable. After enabling the protocol, specify the

appropriate parameter(s) as described in the following sections.

Deﬁning an IP Address for a Remote Peer

Use Site Manager to specify the IP address that the remote peer router should use.

The interface you’re conﬁguring includes this address in its network control

protocol (NCP) negotiations. The default is 0.0.0.0, indicating that this is an

unnumbered interface. You can enter any valid IP address. (For information about

unnumbered IP interfaces and on conﬁguring an adjacent host entry, see

Conﬁguring IP Services.)

Note: If you are using Site Manager and dynamically conﬁguring a router that

has already negotiated its Link Control Protocol, you must force LCP

renegotiation on the interface to implement your changes. To do this, disable

and then reenable the corresponding network control protocol(s).You can

change as many parameters as you need to before forcing the renegotiation.

After making all your changes to any of the addressing or routing protocol

enabling parameters:

1. Set the corresponding network control protocol parameter (for

example, IP Enable) to Disable and, if necessary, apply the changes.

2. Reset the same parameter to Enable and, if necessary, apply the

changes.

Refer to the description of enabling speciﬁc protocols for details.

1 2 ... 53 54 55 56 57 58 59 60 61 62 63 ... 139 140

Keine Kommentare

Avaya Configuring PPP Services Bedienungsanleitung Seite 58