
Customizing PPP
117360-A Rev. A 3-17
To force link renegotiation on this PPP interface, do the tasks in the following
table.
Enabling Link Control on a Line
The link control protocol (LCP) is enabled by default on the interface. Disabling
the Enable (LCP) parameter generates a “close” event to the LCP, and enabling
this event generates an “open” event to the LCP. A major use of this sequence is to
force LCP renegotiation on the interface during dynamic reconfiguration. Doing
so means that any changes you have made to the line parameters are included in
the negotiations.
To enable the link control protocol on this interface, do the tasks in the following
table.
Site Manager Procedure
You do this System responds
1. From the Protocols menu, choose PPP. The Interfaces menu appears.
2. Choose Interfaces. The Interfaces window opens.
3. Choose Lines. The Lines window opens.
(continued)
4. Set Enable (LCP) to Disable.
(See page A-14.)
5. Click on OK. The Interfaces window opens.
6. Choose Lines. The Lines window opens.
7. Set Enable (LCP) to Enable.
(See page A-14.)
8. Click on OK. The Interfaces window opens.
Site Manager Procedure
You do this System responds
1. From the Protocols menu, choose PPP. The Interfaces menu appears.
2. Choose Interfaces. The Interfaces window opens.
3. Choose Lines. The Lines window opens.
Kommentare zu diesen Handbüchern