
Customizing PPP
117360-A Rev. A 3-19
Specifying the Interval between Echo-Request Packets
The value of the Seconds between Xmit of Echo-Request parameter specifies the
number of seconds that the router waits between the transmission of echo-request
packets. A value of 0 (the default) means that this parameter is turned off.
Using the BCC
Navigate to the line prompt for the circuit and enter
echo-requests
seconds
For example, the following command sets the echo-request interval to 5 seconds
on circuit 3/1.
line/3/1# echo-requests 5
Using Site Manager
To set the interval between transmissions of echo-request packets on this
interface, do the tasks in the following table.
3. Choose Lines. The Lines window opens.
4. Set Restart Timer in Seconds.
(See page A-15.)
5. If you have no other PPP line parameters
to configure, click on OK. Otherwise,
continue with the Lines configuration.
The Interfaces window opens.
Site Manager Procedure
You do this System responds
1. From the Protocols menu, choose PPP. The Interfaces menu appears.
2. Choose Interfaces. The Interfaces window opens.
3. Choose Lines. The Lines window opens.
Site Manager Procedure
(continued)
You do this System responds
Kommentare zu diesen Handbüchern