
Configuring PPP Services
3-6 117360-A Rev. A
To specify an IPX network number and remote node number, do the tasks in the
following table.
Configuring AppleTalk
To enable AppleTalk on the interface, use Site Manager to configure an AppleTalk
node number and the AppleTalk routing update protocol for the remote peer to
use.
Defining a Remote AppleTalk Node Number for a Remote Peer
If you want to specify an AppleTalk node number that the peer router should use,
enter it here. There is no default value; you can enter any valid AppleTalk node
number. This interface includes this AppleTalk node number in its network control
protocol negotiations.
Defining the AppleTalk Routing Protocol
You can specify the AppleTalk routing update protocol for the peer router to use.
Since the only option for the AppleTalk Routing Protocol is the Routing Table
Management Protocol (RTMP), you can simply accept the default value. This
interface specifies AppleTalk RTMP as the routing update protocol in NCP
negotiations.
Site Manager Procedure
You do this System responds
1. From the Protocols menu, choose PPP. The Interfaces menu appears.
2. Choose Interfaces. The Interfaces window opens.
3. Set the IPX Network Number.
(See page A-8.)
4. Set the IPX Remote Node Number.
(See page A-9.)
5. If you have no other Interface parameters
to configure, click on OK. Otherwise,
continue with the Interface configuration.
The Configuration Manager window
appears.
Kommentare zu diesen Handbüchern