
117360-A Rev. A 3-1
Chapter 3
Customizing PPP
This chapter describes how to customize and enable PPP services. It assumes you
have configured PPP on the interface using the default parameters, as described in
Chapter 1 and that you understand the PPP concepts in Chapter 2. You should
have read Configuring and Managing Routers with Site Manager or Using the
Bay Command Console, as appropriate for your platform and the tool you are
using. If you are using Site Manager, you should also have
1. Opened a configuration file
2. Specified router hardware, if this is a local mode configuration file
3. Selected the link or net module connector on which you are enabling PPP
You can enable PPP services most easily by accepting all the default parameter
values. You do not have to configure any PPP parameters for PPP to run on your
system.
If, however, you choose to change some or all of the default parameters, you’ll
find the information you need in this chapter. Site Manager lets you configure all
of the PPP parameters; BCC lets you configure a subset of the PPP Line
parameters. For a list of all PPP parameters, see Appendix A, “PPP Parameters.”
Topic Page
Enabling PPP on an Interface Chapter
3-2
Setting Up Remote Addresses Chapter
3-4
Enabling Bridging on an Interface Chapter
3-7
Enabling VINES Support on This Interface Chapter
3-8
Kommentare zu diesen Handbüchern