Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 105)

100

101

Chapter 9 Configuring telephony resources 105

Networking Configuration Guide

• DS/CLID: displays for old North American LS/DS or CLID analog trunk modules, the old analog

MBM, or the GATM with North American DIP switch settings.

• Global: displays for the GATM MBM with no regional DIP switches set.

• Legacy: displays for all other (old) analog trunk modules

Protocol NI-2, DMS-100,

DMS-250,

AT&T4ESS, SL-1,

Euro, ETSI Q.Sig

PRI

Choose the trunk protocol used by your service provider.

The supported protocols are:

PRI-T1: NI (NI-1 and NI-2), DMS-100, DMS-250, AT&T4ESS, SL-1

PRI-E1: ETSI QSIG, Euro, SL-1

Note: SL-1 and ETSI QSIG require an MCDN keycode to display.

BRI: Protocol can also be selected on BRI T-loops under Configuration > Telephony > Loops.

Note: Always check the line protocol with the central office.

NSF Extension None, WATS, ALL

PRI

The Network Specific Facilities (NSF) information element is used to request a particular service from

the network. Settings are based on the type of switch to which the line connects.

Suggested settings:

DMS-100/250: NONE

Siemens ESWD, Lucent 5ESS: WATS

GTD5, DMS-10: ALL

When you select NONE, the NSF extension bit is not set for any service.

When you select WATS, the NSF extension bit is set for unbanded OUTWATS calls.

When you select ALL, the NSF extension is always set for all CbC services.

Appears only for NI protocol.

Protocol type User, Network

PRI

When you select SL-1 protocol, an additional setting, Protocol type, appears.

SL-1 protocol is a private networking protocol. Use this protocol to designate a BCM node as a

Network (controller). The default setting is User (client). In public network configurations, the CO is

generally considered the Network side or controller.

Applies to SL-1 protocol only.

B-channel

selection

sequence

Ascending Sequential

Descending

Sequential

PRI

Defines how B-channel resources are selected for call processing.

Answer timer 1, 2, 3, 4, or 5 sec.

E&M PRI

Set the minimum duration of an answer signal before a call is considered to be answered.

Table 14 Module parameters values (Sheet 2 of 4)

Attribute Value Module/line type

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 105

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50