Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 427)

100

101

427

Networking Configuration Guide

Chapter 53

Call Security: Configuring Direct Inward System Access

(DISA)

This following describes the telephony configuration that allows users to call from a remote site

into the system to access system features.

The following paths indicate where to access DISA settings in Element Manager and through

Telset Administration:

• Element Manager:

— Configuration > Resources > Telephony Resources

— Configuration > Telephony > Dialing Plan > Public Network

— Configuration > Telephony > Dialing Plan > Private Network

• Telset interface: **CONFIG > System prgrming > Access codes

Refer to the following:

• “Remote access overview” on page 427

• “Setting up remote access on lines” on page 430

Remote access overview

To control access from the public or private network, you can configure auto-answer trunks to

answer with DISA. Remote callers hear a stuttered dial tone and must then enter a CoS password

that determines what they are allowed to do in the system.

• Auto-answer T1 loop start and T1 E&M trunks are configured to answer with DISA by

default.

• T1 DID trunks: You cannot configure T1 DID trunks to answer with DISA. If you want

incoming T1 DID calls to be answered with DISA, configure the system with a DISA DN.

Incoming T1 DID calls that map onto the DISA DN are then routed to a line that has DISA.

Task: Configuring DISA DNs, Auto DNs, Answering with DISA

• Set up the system parameters for system users to call into the from a remote location. Note that

Remote Access Packages are required for private network trunks, as well.

1 2 ... 422 423 424 425 426 427 428 429 430 431 432 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 427

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50