Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 279)

100

101

Chapter 28 Dialing plan: Public network 279

Networking Configuration Guide

Deleting a DN prefix

1 On the Public Network DN Lengths panel, click the DN prefix you want to delete.

2 Click Delete.

3 Click OK on the confirmation dialog.

Outgoing public calls routing

Outgoing public calls from within the system typically have the routes set to Public. Refer to

“Setting up a destination for local calling” on page 249. The NPI/TON gets sent as Unknown/

Unknown. The public called number length is based on the Public DN lengths table in the Public

networks dialing plan.

MCDN trunks also allow public call types when tandeming calls from another system on the

private network. Some of these systems use specific call types that the BCM needs to recognize to

pass on correctly. Also refer to “Using the MCDN access codes to tandem calls” on page 257.

Carrier Codes

The Carrier Codes table allows you to enter a maximum of five carrier code prefixes.

• You can define up to five carrier codes.

• Entries may be predefined for a specific country profile, but you can remove these defaults.

• Each entry consists of an equal access identifier code prefix (one to six digits) and a carrier

identification code length (one digit, 1 to 9).

• Each entry is identified by the prefix digits themselves.

Note: Dialing prefixes are used system-wide for users to make calls. Delete

prefixes with caution.

Type of call NPI/TON BCM prepend access code BCM monitor display

Local E164/Local Local access code (9) E.164/Subscriber

National E164/National National access code (X1) E.164/National

Special calls

(international, 911,

etc.)

Private/Special Special access code (9)

1 2 ... 274 275 276 277 278 279 280 281 282 283 284 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 279

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50