Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 398)

100

101

398 Chapter 46 Setting up VoIP trunks for fallback

NN40020-603NN40020-603

The systems already communicate through a PRI line, which will be configured to be used for

fallback. Both systems already have all keycodes installed for eight VoIP lines, and resources

properly allocated for VoIP trunking. For information about keycodes, see the Keycode

Installation Guide (NN40010-301).

Each BCM has 10 telephones that will be using VoIP lines. In this setup, only eight calls can be

sent or received over the VoIP trunks at one time. If all 10 telephones attempt to call at the same

time, two of the calls will be rerouted to the PSTN or other alternate routes if multiple routing is

set up in the destination code schedule.

System programming for networking and fallback routes

Table 81 provides the settings that are required for both systems to create a fallback network.

Table 81 Fallback configuration to create fallback between two systems (Sheet 1 of 2)

Task Settings for

Santa Clara

Settings for

Ottawa

Location in Element Manager

Set up a Control set for each

VoIP line

3321 2221 Configuration > Telephony >

Sets > All DNs

Set first preferred Codec G.729 Configuration > Resources >

Telephony Resources >

IP Trunks, H.323

Media Parameters tab.

Set voice activity detection Selected

Set Jitter Buffer Medium

Put 8 VoIP lines into the

same line pool

BlocF

Give all system telephones

access to the VoIP line pool

BlocO Configuration > Telephony >

Dialing Plan > Line Pools

Confirm or assign target lines

to all DNs or Hunt Groups t.

<targetline #> Configuration > Telephony >

Lines >Target Lines

Configure the target lines that

you assigned.

Control set: 3321 Control set: 2221 Configuration > Telephony >

Lines > Target Lines >Line

XXX

Trunk/Line data:

Line Type: Private

If busy: To prime

Prime set: DN

3321

Received number:

3322

Prime set: DN

2221

Received number:

2244

Create remote gateway

record for remote BCM

Destination IP:

47.62.54.1

Destination IP:

47.62.84.1

Configuration > Resources

>Telephony Resources >

IP Trunks > Routing Table

Destination digits note: In this

case, the systems use a

Coordinated Dialing Plan (CDP)

network, and the destination

digit is included in the DN.

QoS Monitor: Enabled

Transmit Threshold: 3.5 (moderate

quality)

Gateway Type: BCM3.6

Gateway protocol: None

Destination Digits

(Ottawa): 2

Destination Digits

(Santa Clara): 3

1 2 ... 393 394 395 396 397 398 399 400 401 402 403 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 398

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50