Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 197)

100

101

Chapter 20 BRI ISDN: BRI T-loops 197

Networking Configuration Guide

Configuring BRI T-loop parameters

To configure BRI T-loop parameters

1 Identify the loop as a T-loop (refer to “Configure loop type and general parameters” on

page 188).

• Protocol (ETSI and ETSI-QSIG loops, only)

• ONN block state

• Overlap receiving

• Overlap length

• Send name display (ETSI-QSIG only)

2 Enter the details for the loop (refer to “T-loop SPIDS and network DNs” on page 190).

North American systems, only:

•SPID

• B-channel

•Network DN

• Call type

ETSI and ETSI-QSIG T-loops (UK profile)

• Clock source

3 If applicable, configure D-packet service for the loop (refer to “T-loops D-packet service” on

page 192).

4 Provision the loop and the loop lines (refer to “Provisioning module lines/loops” on page 112).

5 Program the BRI lines (refer to “Configuring BRI lines” on page 197). If the lines are set to

auto-answer, put the lines into line pools (A to O) and configure target lines.

6 Assign the lines/line pools and target lines to the telephones. Refer to “Line Access - Line

Assignment tab” and “Line Access - Line Pool Access tab” in the Device Configuration

Guide (NN40020-300).

Configuring BRI lines

There are two lines for every ISDN BRI loop that is designated as a T-loop. Unlike PRI lines,

these lines can be set to either manual or automatic answer when using for remote call-ins.

The following paths indicate where to access the line configuration menu through Element

Manager and through Telset Administration:

• Element Manager: Configuration > Telephony > Lines > Active Physical Lines, Inactive

Lines, All Lines

• Telset interface: **CONFIG > Lines

1 2 ... 192 193 194 195 196 197 198 199 200 201 202 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 197

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50