Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 405)

100

101

405

Networking Configuration Guide

Chapter 48

Port ranges overview

The Port Ranges panel provides a list of which Ports are currently being used for RTP/UDP, UDP,

and Signaling. In the case of RTP over UDP and UDP, it allows changes to the ports being used.

For information on configuring port ranges, see “Port Ranges panel” on page 407.

RTP over UDP

RTP over UDP is used by IP sets to connect to media gateways, and by IP trunks to connect to

remote devices or PDM devices. All of these services require RTP over UDP. Each media gateway

uses two ports. By default, RTP over UDP is set to use the port range 28000 - 28255. It’s

recommended that you keep 256 ports configured for RTP over UDP. The BCM requires a

minimum of 110 ports to support necessary services. This includes 32 IP sets, 11 voice mail and

contact center voiceports, and 12 trunks. Each of these devices requires two RTP over UDP ports.

You can configure up to ten separate ranges of ports.

UDP

UDP is used for T.38 Fax over UDP. By default, it uses the Range 20000 to 20255. You can

configure up to ten separate ranges of ports. While the system can function with 12 ports, it is

recommended that 256 ports are reserved.

Signaling Ports

Signaling ports are used by the system and cannot be modified. They are provided to show where

conflicts with UDP or RTP occur.

Warning: Port configuration should not be changed unless absolutely necessary, such as

in instances where port configurations are causing conflicts, or if a firewall is restricting

communications over certain ports.

1 2 ... 400 401 402 403 404 405 406 407 408 409 410 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 405

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50