Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 382)

382 Chapter 44 Configuring VoIP trunk gateways

NN40020-603NN40020-603

— If your network uses a gatekeeper (H.323 trunks only), there are also specific settings

that must be set on the your system to recognize the gatekeeper, and also within the

gatekeeper application, so that VoIP lines are recognized. Refer to “VoIP

interoperability: Gatekeeper configuration” on page 389. If there is a gatekeeper on

the network, you do not have to configure remote gateway settings.

— If you plan to use H.323 trunking and you have a firewall set up, ensure that the ports

you intend to use have been allowed.

• SIP network applications consideration:

— If you plan to use SIP trunking, and you have a firewall set up, ensure that the ports

you intend to use have been allowed.

“Using VoIP to tandem systems” on page 327, and “Configuring fallback over a VoIP MCDN

network” in the Device Configuration Guide (NN40020-300).

Configuring VoIP trunk media parameters

The VoIP trunk media parameters allow you to specify the order in which the trunk will select IP

telephony system controls for codecs, jitter buffers, silence suppression and payload size.

The following path indicates where to access the VoIP trunk media parameters in Element

Manager:

• Element Manager: Configuration > Resources > Telephony Resources > IP Trunks

For details about the fields on this panel, refer to “H323 Media Parameters” on page 122 and “SIP

Media Parameters” on page 126.

1 On the Modules panel, in the Module type column, select the IP Trunks line.

2 In the bottom panel, select the H323 or SIP Media Parameters tab.

3 Enter the information that supports your system. Ensure that these settings are consistent with

the other systems on the network:

• Preferred Codecs: Choose codecs in the same order for all remote equipment.

• Settings:

— Enable Voice Activity Detection: Disable or enable this feature, based on network

requirements. Also refer to “Silence suppression” on page 529.

— Jitter buffer - Voice: Either choose auto to let the system determine resource

availability, or choose a buffer size.

— Payload Size: Change the defaults to coordinate with other systems on the network.

Operations note: Fax tones that broadcast through a telephone speaker may disrupt calls at other

telephones using VoIP trunks in the vicinity of the fax machine. Here are some suggestions to

minimize the possibility of your VoIP calls being dropped because of fax tone interference:

— Locate fax machine away from other telephones.

— Turn the speaker volume on the fax machine to the lowest level, or off, if that option is

available.

1 2 ... 377 378 379 380 381 382 383 384 385 386 387 ... 567 568

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 382