
352 Chapter 40 Configuring centralized voice mail
NN40020-603NN40020-603
For details about setting up the CallPilot parameters and features, refer to the CallPilot Manager
Set Up and Operations Guide and the other CallPilot supporting documentation.
Meridian system as host
If you are using a voice mail system connected to a Meridian 1 as a host system, ensure that the
systems are set up to be compatible with each other.
CallPilot compatibility
If you are planning to use M1-based CallPilot software for the voice mail system, there are no
compatibility issues.
Meridian Mail compatibility issues
If you are using Meridian Mail as the host system, ensure that the Meridian has the following:
• Meridian Mail rel. 7 (MM7) or above
• the appropriate number of PRI cards and D-channel handlers to support the PRI links to all the
BCMs using the system.
Special requirements:
• Over a PRI SL-1 line: Meridian 1 must be on Release 19 or greater.
• Over VoIP: Meridian one must be installed with an IPT card version 3.0 or newer
• Meridian 1 requires the network ID of the BCM, select Configuration > Telephony > Dialing
Plan > Private Network in the Element Manager. The ID is a number between 1 and 27, and
is defined by the Meridian system administrator.
Also refer to “System set up for satellite systems” on page 353 for specific call features available
from a Meridian 1-based voice mail system.
System set up for host system
The system that hosts the voice mail needs to ensure that incoming calls are directed to the voice
mail service.
Process assumptions:
• Private network is set up, with MCDN, between any nodes that need to access voice mail on
this system.
• All systems are using the CDP dialing plan, and you have set up the correct routing to these
systems.
Note: CallPilot for BCM accepts network-wide and site-specific VPIM
broadcast messages from M1 CallPilot, if the VPIM prefix in the
message address matches the local mailbox prefix.
Kommentare zu diesen Handbüchern