Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 198)

100

101

198 Chapter 20 BRI ISDN: BRI T-loops

NN40020-603NN40020-603

Prior programming:

Configuring provisioned BRI line features

The following procedure describes the fields that need to be confirmed or set for these lines. For

detailed field descriptions, refer to “Configuring lines” on page 129.

To configure provisioned BRI line features

1 Confirm or change the settings on the Trunk/Line Data main panel:

• Trunk Type: BRI-ST (determined by profile and type of BRI module)

• Name: Identify the line or line function.

• Control Set: Identify a DN if you are using this line with scheduling.

• Line Type: Define how the line will be used. If you are using routing, ensure it is put into

line pool (A to O).

• Prime Set: If you want the line to be answered at another telephone if the line is not

answered at the target telephone, otherwise, choose None.

• Pub. Received #: Not applicable.

• Priv. Received#: Not applicable.

• Distinct Ring: If you want this line to have a special ring, indicate a pattern (2, 3, or 4).

• Subpanel, under Restrictions tab: Use remote package: If this line is used for remote

call-ins or is part of a private network, ensure you specify a valid package.

2 Configure the trunk/line data (Properties tab):

• Auto privacy: If you activate this feature, the line is available only to the telephone that

answers the call.

• Answer mode/Answer with DISA: If this line is used for remote call-ins, determine how

you want the line to answer (automatically, or requiring more user input). If the answer

mode is set to Automatic, decide whether the caller will be immediately connected to the

system or whether a stuttered dial tone will require the caller to enter a CoS password.

• Aux. ringer: If your system is equipped with an external ringer, you can enable this setting

to allow this line to ring at the external ringer.

• Full autohold: This allows telephones to put a line on hold if the user picks up another line

or starts to dial out on another line.

• Voice Message Center: If the system is using a remote voice mail, select the center

configured with the contact number.

BRI module: Installed and configured. Refer to “Trunk Module

Parameters” on page 104.

BRI loops are configured as T loops. Refer to “Configuring BRI T-loop

parameters” on page 197.

BRI loop lines are provisioned. Refer to “Provisioning module lines/

loops” on page 112.

1 2 ... 193 194 195 196 197 198 199 200 201 202 203 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 198

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50