Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 207)

100

101

Chapter 22 Configuring CLID on your system 207

Networking Configuration Guide

Programming incoming CLID

Telephones can receive Name, Number, and Line display for incoming calls over trunks that

support CLID or between telephones within the system. The following describes the different

areas where these capabilities are configured.

Digital, analog, and VoIP lines support CLID for incoming calls, and no special programming is

required for the feature on these lines for BCM digital or IP phones.

Allowing CLID for telephones (incoming)

Target lines and analog CLID trunks connected to a GATM:

1 Click Configuration > Telephony > Sets > Active Sets > Line Access, and then select the

DN record for a telephone assigned with analog lines that support CLID.

2 On the Line Assignment tab, select a line that supports CLID.

3 Select the check box beside the Caller ID Set field of the highlighted row.

4 Repeat for each line assigned to the telephone.

5 Repeat above steps for telephones assigned with these lines.

Using alpha tagging for name display (incoming)

To set up alpha tagging on your system

1 To determine the name to display, you add a system speed dial for the number, entering a

display name. Refer to “Configuring system speed dial numbers” in the Device Configuration

Guide (NN40020-300).

2 To determine how many digits of the dialed number and the system speed dial must match

before a name is displayed, you set the Clid match length setting to the required number

(1 to 8).

Note: If no configuration is done, CLID will show up after answering a

call unless Feature 811 is used. To make CLID appear before answer,

you must set the Caller ID set on the set programming.

Note: Only 30 telephones can be assigned CLID for a line.

Note: You can increase the default number of system speed dials from 70 to 255 if you

want to provide an extensive CLID list.

1 2 ... 202 203 204 205 206 207 208 209 210 211 212 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 207

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50