Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 119)

100

101

Chapter 9 Configuring telephony resources 119

Networking Configuration Guide

Forward redirected OLI <check box> If the check box is selected, the OLI of an internal telephone

is forwarded over the VoIP trunk when a call is transferred to

an external number over the private VoIP network.

If the check box is cleared, only the CLID of the transferred

call is forwarded.

Send name display <check box> When selected, the telephone name is sent with outgoing

calls to the network.

Remote capability MWI <check box> This setting must coordinate with the functionality of the

remote system hosting the remote voice mail.

Normal route fallback

None

Prime set

Select None or Prime set. If Prime set is selected and the

outgoing IP trunk leg of the call in a tandem scenario cannot

be completed, the call will terminate on the prime set for the

line.

Default: None

Gateway protocol None

SL1

CSE

Both these protocols require a keycode.

SL1: Use this protocol only for BCM 2.5 systems

CSE: Use this protocol for BCM 3.0 and later systems. This

protocol supports Meridian 1 IPT.

Otherwise, use None.

Gatekeeper digits <0-9> If dialed digits match gatekeeper digits, the call is routed via

H323 protocol.

If the digits do not match, the call is routed via SIP protocol.

Gatekeeper wildcard <check box> If selected, all dialed digits match gatekeeper digits and

VoIP calls will be routed through the gatekeeper.

Ignore in-band DTMF

in RTP

<check box> If selected, the BCM ignores audible in-band DTMF tones

received over VoIP trunks after the BCM connects the

remote end to a locally hosted call center application, or a

locally hosted CallPilot application such as auto attendant,

voice mail or IVR.

Note: This setting is useful (should be selected) when the

far end is a Call Server 2000 (CS2K) & Packet Voice

Gateway (PVG) combination where the PVG is provisioned

for OOBDTMFSupp=FullSupport resulting in the PVG +

CS2K sending out-of-band, as well as in-band, DTMF tones

at the same time to the BCM. The PVG MAY not send both

tone notifications depending on whether the call is using

G711 and the version of the CS2K software release (i.e.

SNxx).

This setting should be co-coordinated with the CS2K

administrator.

Default: Cleared

Table 22 H323 Settings fields (Sheet 2 of 5)

Field Value Description

1 2 ... 114 115 116 117 118 119 120 121 122 123 124 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 119

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50