Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 106)

106 Chapter 9 Configuring telephony resources

NN40020-603NN40020-603

Disconnect

timer

60, 100, 260, 460, or

600 milliseconds

Loop T1

Specify the duration of an Open Switch Interval (OSI) before a call on a supervised external line is

considered disconnected. This setting must match the setting for the line at the central office (CO).

You must enable disconnect supervision by changing the Line Trunk mode attribute. Under the

Telephony Services sub-heading, choose Lines and Line/trunk Data.

Clock Source Primary External

Secondary External

Internal

T1 PRI *BRI S/

DASS2

Designates whether the DTM/BRI acts as a primary or secondary timing component for an external

timing source or as the internal timing source.

Note: A BRI module can be programmed with primary/secondary clock source, however, it is

recommended that a BRI module always be set to Internal if a DTM exists on the system to be the

Primary External clock source.

Warning: Changing the clock source may disconnect calls.

If you change the clock source for your system, you may cause your system DTM interface(s) to reset,

resulting in dropped calls. Choose a suitable time to change the clock source and use the Page

feature to inform users of possible service disruptions.

Send Name

Display

Select or clear

PRI *BRI

QSIG

When you select this check box, the system sends a specified outgoing name display (OLI) from the

calling telephone.

Appears only for Protocols: SL-1, NI, DMS-100, DMS-250, or PRI QSIG.

Remote

Capability MWI

Select or clear

PRI

Use this setting to indicate MWI compatibility on the specific loop(s) that you are using to connect to

the central voice mail system on a Meridian 1, that has the MWI package installed, with the RCAP

setting set to MWI.

Appears only for SL-1 protocol.

Host node M1, Embark, IDPX,

DSM

DNPSS

DPNSS cards connected to Embark switches have a different way of handling call diversion, therefore,

when you provision a DTM for DPNSS, you must indicate what type of switch the lines are connected

to.

When you select the Embark switch, calls are diverted using the Call Forwarding feature instead of

call diversion.

Local Number

Length

DPNSS

This number allows the system to determine how many digits to read on an incoming call to determine

that the call is meant for this system.

Maximum

Transits

Default: 31

PRI

Indicate the maximum number of times that a call will be transferred within the SL-1 network before

the call is dropped. Protocol must be set to SL-1 to display this field.

Table 14 Module parameters values (Sheet 3 of 4)

Attribute Value Module/line type

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 106

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50