Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 136)

100

101

136 Chapter 10 Configuring lines

NN40020-603NN40020-603

ANI Number

DID E&M

<check box> Define whether the telephone number of the caller will be

shown for this line.

For T1 E&M and T1 DID trunks connected to a DTM, this setting

only appears if Signaling is set to WinkStart.

The central office must deliver ANI/DNIS in DTMF mode. No

additional equipment is required.

DNIS Number

E&M

<check box> Defines whether the digits dialed by an external caller on this

line will be shown.For T1 E&M trunks connected to a DTM, this

setting only appears if Signaling is set to WinkStart and Answer

mode is set to Manual.

Distinct Rings in

use

<read-only> Indicates if a special ring has been assigned. See Distinct Ring

on the main table.

Answer mode

Loop GS E&M BRI DPNSS

Manual

Auto

Define whether a trunk is manual or automatic answer.

Auto answer mode allows the trunk to be a shared resource by

the system telephones. This shared resource is created through

routing to target lines or using DISA.

For auto answer trunks being used to allow remote call-in from

system users, the trunk can be configured to answer with a

straight dial tone, if DISA has not been enabled. It can also be

configured to answer with a stuttered dial tone if DISA is

enabled and the caller is expected to enter a CoS password.

The CoS password defines which system features the caller is

permitted to access.

Manual answer trunks are assigned to one or more telephones.

The assigned telephones exclusively own the line.

Note: You require Disconnect supervision on the line if loop start trunks are to

operate in auto-answer mode.

Answer with DISA

Loop GS E&M BRI

<check box> Define whether the system prompts a caller for a six-digit class

of service (CoS) password.

This setting appears for T1 loop

start, T1 E&M lines that have auto-answer mode, and analog

trunks. Set this option to No for T1 E&M lines on a private

network that have auto-answer mode.

To program DISA on a PRI trunk you need to specify a DISA

DN, see “Call Security: Configuring Direct Inward System

Access (DISA)” on page 427 and “Dialing plan: Private network

settings” on page 281.

Table 29 Preferences details fields for lines (Sheet 2 of 3)

Attribute Value Description

Legend: Loop = analog/digital loop; GS = ground start; DID = DID; E&M = E&M; BRI = BRI; DPNSS

= DPNSS; VoIP = VoIP; TL = Target and DASS2. Note: PRI fields are all included under the main

panel.

1 2 ... 131 132 133 134 135 136 137 138 139 140 141 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 136

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50