Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 134)

100

101

134 Chapter 10 Configuring lines

NN40020-603NN40020-603

Preferences (lines)

The Preferences tab shows information that may vary from trunk to trunk. Most of this information

needs to coordinate with the line service provider equipment.

The Preferences tab is shown in Figure 37.

Line Tuning Digit Loop (analog

only)

<drop-down

menu>,

none

0-9

If the Line Tuning Digit dropdown list is cleared, line tuning is

disabled. Otherwise, line tuning is enabled. By default the digit

used to remove dial tone is 1. In most configurations, the digit 1

is sufficient to remove dial tone so that line tuning can execute.

In the rare case where the central office requires an alternate

digit, the technician can choose a digit other than 1.

Signaling

DID E&M

WinkStart

Immediate

DelayDial

Select the signal type for the line. The immediate setting does

not appear for T1 E&M or T1 DID trunks connected to a DTM if

the Dial mode is set to tone.

Make sure that this matches the signal type programmed for the

trunk at the other switch.

Link at CO

Loop (analog

only)

<check box> Some exchanges respond to a Link signal, also called hook

flash (FEATURE 71), by providing an alternative line for making

outgoing calls.

Enabling Link at CO causes the system to apply the restrictions

on outgoing calls to the digits dialed after the Link signal. As

well, the call on the alternative line is subject to all restrictions.

Disabling Link at CO prevents a Link signal from resetting the

BCM restrictions in cases where the host exchange does not

provide an alternative line.

Table 28 Properties line settings (Sheet 2 of 2)

Attribute Value Description

Legend: Loop = analog/digital loop; GS = ground start; DID = DID; E&M = E&M; BRI = BRI; DPNSS

= DPNSS; VoIP = VoIP; TL = Target. Note: PRI fields are all included under the main table.

1 2 ... 129 130 131 132 133 134 135 136 137 138 139 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 134

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50