Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 81)

100

101

Networking Configuration Guide

Chapter 6

Module configuration: Trunk modules

This following describes the Element Manager headings that define and control the settings for the

trunk media bay modules installed on your system.

The following paths indicate where to access the trunk modules in Element Manager and through

Telset Administration:

• Element Manager: Configuration > Resources > Telephony Resources

• Telset interface: **CONFIG > Hardware

For an overview of the Telephony Resources panel, refer to “Configuring telephony resources” on

page 101.

Prerequisites

Complete the following prerequisites checklist before configuring the modules.

Task: To confirm settings for the trunk media bay modules installed in the system.

• Confirm that all prerequisites are complete. Refer to “Configuring the trunk module

parameters” on page 83.

• Confirm or set module parameters as follows:

• If your module supports T1, PRI, or DASS2, refer to “Call-by-Call Service

Selection” on page 108 and “Provisioning module lines/loops” on page 112.

• For other types of trunk modules, configure each line record. Refer to

“Configuring lines” on page 129.

• Provision modules and confirm auto-entry information. Refer to “Provisioning

module lines/loops” on page 112.

System hardware is installed and operating correctly.

All relevant central office/service provider information for the trunk type

has been obtained.

Keycodes have been activated for core module trunks.

Expansion modules are installed and operating, and LEDs are correct.

1 2 ... 76 77 78 79 80 81 82 83 84 85 86 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 81

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50