Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 521)

100

101

Chapter 70 Dial Up Interfaces panel 521

Networking Configuration Guide

Creating an automatic dial-out interface

Management applications such as SNMP trap dial out, Scheduled Log transfer, Scheduled Backup,

and Scheduled CDR records transfer can use automatic dial-out over an ISDN or Modem

interface. To configure the automatic data transfer, the administrator must configure a static route,

with the auto dial-out field selected, and associate it with the application. When data is sent to the

destination address, the network recognizes the address of the application, and triggers the dial-out

to establish the connection.The packets are then sent over the link to the destination.

Notes:

• The dial-out interface must be enabled to configure static routes.

• The disconnect time for the interface must be greater than 60 seconds. This is configured on

the Link Parameters tab of the selected interface under Configuration > Resources > Dial

Up Interfaces.

• Auto dial-out routes cannot be added if the interface is already manually connected, unless the

interface is already connected with auto dial-out routes configured.

Second dial-in IP

Address

<IP Address> The IP address that will be assigned to the BCM side of the

second dial-in connection. This is only assigned if Remote

Assigned is disabled.

Default: 10.10.18.2

Remote IP Address Specification

Assign IP address to

remote

<check box> When enabled, BCM will assign the remote end of the

connection one of the IP addresses specified below.

When cleared, the remote side will assign it’s own IP address.

Default: enabled

First dial-in IP Address <IP Address>

The IP address that will be assigned to the remote side of the

first dial-in connection. This is only assigned if Assign IP

address to remote is enabled.

Default: 10.10.18.10

Second dial-in IP

Address

The IP address that will be assigned to the remote side of the

second dial-in connection. This is only assigned if Assign IP

address to remote is enabled.

Default: 10.10.18.11

Caution: Select the Enable Dial Back-Up check box to enable Dial Back-up on

the router. Do not change the other Basic or Advanced Settings.

Table 118 ISDN Dial-In Parameters fields (Sheet 3 of 3)

Attribute Value Description

1 2 ... 516 517 518 519 520 521 522 523 524 525 526 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 521

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50