Avaya BCM50 Konfigurationsanleitung Seite 188

  • Herunterladen
  • Zu meinen Handbüchern hinzufügen
  • Drucken
  • Seite
    / 568
  • Inhaltsverzeichnis
  • LESEZEICHEN
  • Bewertet. / 5. Basierend auf Kundenbewertungen
Seitenansicht 187
188 Chapter 19 BRI ISDN: BRI loop properties
NN40020-603NN40020-603
Configure loop type and general parameters
The Loops table displays the BRI loops for an installed module and the settings that are common
to both T-loops and S-loops. Figure 58 illustrates the Loops table.
Figure 58 Loops table
Table 31 describes the fields found on the Loop main panel.
Table 31 Loops main panel (Sheet 1 of 2)
Attribute Value Description
Loop <X01-X04> Each BRI module supports four loops (eight lines for T-loop
programming).
Type T
S
This setting defines whether the loop supports trunks
(T-loop) or device connections (S-loop).
Note: This variable may be different for different market
profiles.
Protocol Euro
QSIG
NI-2
Select the appropriate ISDN protocol.
The values displayed depend on both the market profile and
software keycodes.
Euro - ETSI ISDN standard
QSIG - also an ETSI standard. Only appears if the ETSI
QSIG keycode is loaded.
NI-2
Sampling
(S-loops only)
Adaptive
Fixed
N/A
Select a sampling rate for the S-loop.
Fixed: two or more S-interface devices use the loop, and
the length of the loop is less than 200 m (650 ft.).
Adaptive: two or more S-interface devices use the loop, and
the length of the loop is greater than 200 m (650 ft.). If one
device is using the loop, the length of the loop can be a
maximum of 1000 m (3230 ft)
ONN blocking Suppression bit
Service code
Set the Outgoing Name and Number (ONN) Blocking.
When you activate ONN, a user can press FEATURE 819
to block the outgoing name and number on a per call basis.
Programming note: Ensure that all telephones that have
this feature available are assigned valid OLI numbers. Refer
to “Programming outgoing number display (OLI)” on
page 209.
Seitenansicht 187
1 2 ... 183 184 185 186 187 188 189 190 191 192 193 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare