Avaya BCM50 Konfigurationsanleitung PDF herunterladen (Seite 137)

100

101

Chapter 10 Configuring lines 137

Networking Configuration Guide

Restrictions (Line and Remote)

Assigning Line restrictions and Remote Access Package restrictions are part of the configuration

for controlling calls out of the system (line restrictions) and into the system from a private network

node or from a remote user calling in over the PSTN lines (Remote Access Packages).

The following paths indicate where to access the restriction settings in Element Manager and

through Telset Administration:

• Element Manager: Configuration > Telephony > Lines

• Telset interface:**CONFIG > Lines or **CONFIG > Terminals and Sets

The Restrictions tab is shown in Figure 38.

If busy TL

To Prime

Busy Tone

Define whether a caller receives a busy tone or the call

forwards to the prime telephone when the target line is busy.

Busy tone only works for PRI trunks.

Tips: The duration of an open switch interval (OSI) before BCM disconnects a call is

programmed by the Disconnect timer setting. Refer to “Trunk Module Parameters”

on page 104.

Voice Message

Center

Loop GS DID E&M BRI DPNSS VoIP TL

Center 1 -

Center 5

If this line connects t o a remote voice mail, either through the

private network or at the Central Office, indicate which Center

number has been configured with the contact number.The

system calls that number to check voice mail messages when a

message indicator is presented to a telephone.

Redirect to

Loop GS DID E&M TL

<dial string> Enter a dial string (including destination code) to redirect the

line to an external telephone, such as a call attendant on

another system.

If you want to stop redirection, you need to delete the dial string

and allow the record to update.

Warning: If the dialstring is set up, the line will immediately be

redirected out of the system not ringing any telephone.

Warning: Enable modules

If you disabled any trunk media bay modules prior to performing programming, enable them now to

ensure your system will function properly.

Table 29 Preferences details fields for lines (Sheet 3 of 3)

Attribute Value Description

Legend: Loop = analog/digital loop; GS = ground start; DID = DID; E&M = E&M; BRI = BRI; DPNSS

= DPNSS; VoIP = VoIP; TL = Target and DASS2. Note: PRI fields are all included under the main

panel.

1 2 ... 132 133 134 135 136 137 138 139 140 141 142 ... 567 568

Kommentare zu diesen Handbüchern

Keine Kommentare

Avaya BCM50 Konfigurationsanleitung Seite 137

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Software Avaya BCM50